Renovating an overgrown bullace (wild plum) hedge: four stages from a tall, gappy boundary back to a working fruiting hedge
Bullace (Prunus insititia) turns up in older field boundaries across east Kent more often than most people realise. It is closely related to blackthorn and to domesticated plums and damsons, and its small round fruits, purple-black when ripe in October, were once gathered from farm hedgerows all across this part of Kent. Left uncut it grows tall and multi-stemmed, the boundary loses its stock-proof value, and the fruit crop ends up three metres off the ground. Renovation is straightforward but it follows a different logic from hawthorn, hazel or blackthorn, mainly because of one disease risk that changes the preferred timing.
Before
A bullace boundary hedge that has not been cut for ten or more years can reach four to five metres, with long arching stems carrying their leaves and fruit at the very top. The base of the hedge is hollow: the lower stems have died back in the shade of the canopy above, leaving a line of bare, tangled old wood that an adult can walk through. The field side has a distinct lean to it where the unpruned leaders have pushed out over the boundary. The October fruit is present but completely out of reach, and whatever does fall gets taken quickly by blackbirds and fieldfares working along the bottom of the hedge. From the road or lane the boundary looks overgrown; in practice it is not holding anything in or out.
After
Three seasons after a staged renovation, the same boundary sits at one and a half to two metres, with dense, multi-stemmed regrowth filling the hedge line from the base up. The blossom in March and April is accessible to early bumblebees and hoverflies. The October bullace crop hangs at arm's reach: small purple fruits with a bloom on them that are sharp raw but make a good jam or sloe-gin equivalent, and which fieldfares and redwings arriving through the village in October strip steadily from the lower branches. The base of the hedge is thick enough to hold stock, and the hedge line is back to doing the job it was planted for.
Stage 1: late-winter assessment (January)
The first thing to do, before any cut, is a careful walk along the whole length. Bullace belongs to the Prunus genus, which means it is susceptible to silver leaf disease (Chondrostereum purpureum), a fungal infection that enters through fresh cuts and spreads through the wood, producing a silvery discolouration on the leaves and a brown stain in the heartwood. The spores are present year-round but are most active in wet conditions. This single fact has a significant bearing on how and when you plan the work.
During the January assessment, look for any existing silver leaf symptoms: leaves (from the previous summer, still clinging to the hedge in places) with a distinctive silvery metallic sheen, and any branches showing die-back beyond the point of a previous cut. Check the wood by cutting a small section from a suspicious branch: brown staining in the heartwood is a reliable indicator. A hedge with significant active silver leaf should still be renovated, but any badly affected stems should be removed entirely rather than cut back to a stump, and the cut material should not be left in piles in contact with the living hedge.
Also during the assessment: count the stems and note where the hedge is thickest and where the gaps are. A bullace hedge in poor condition typically has a few very strong leader stems and a mass of thinner, crowded, inward-facing growth at mid-height with almost nothing at the base. The renovation cut will need to deal with both.
Stage 2: the first-side cut (late February, before bud break)
Bullace renovation is best staged over two winters. Unlike hazel, which can take a complete hard coppice cut in a single winter operation, Prunus species respond better to a staged approach: cutting one side in the first winter and completing the other side the following year. This gives the root system enough above-ground material to sustain itself through the growing season and produces a more even recovery.
The timing for the first-side cut is late February, as late as possible before the buds break into active growth. The reasoning is this: the ideal window for cutting any Prunus species to minimise silver leaf risk is dry summer weather, when the fungal spores are least active. In practice, cutting a heavily overgrown boundary hedge in high summer is not feasible during nesting season (see the callout below), so late winter, when the wood is still dormant and the weather is usually drier than autumn, is the practical compromise. The key is to cut in dry conditions, not immediately before or during rain.
Bullace blossom is early: check the nesting season dates before you cut
Section 1 of the Wildlife and Countryside Act 1981 makes it a criminal offence to intentionally damage or destroy an active wild bird's nest, or to injure or take a wild bird. The practical caution window is 1 March to 31 August, extending into September for late broods. Bullace flowers early, in late March and April, and blackbirds, song thrush and dunnock all use thick Prunus hedges as early nesting sites. In a mild year, nesting in a bullace hedge can begin before the end of February. If you plan a late-February renovation cut and the weather has been unusually warm, check each section of the hedge before cutting: if you find an active nest or a bird sitting tight, that section stays uncut until the brood has fledged. The farmland hedgerows between Staple and Adisham carry genuine bird interest, including yellowhammer along the field margins, and a pre-cut check takes only a few minutes.
The cut itself takes back one side of the hedge by roughly two-thirds of its current height and width. If the hedge is currently five metres, aim to leave the cut face at about two metres. Use a pruning saw or bow saw for the larger stems (anything over six centimetres), loppers for the rest. Make clean cuts at a slight angle so water runs off: ragged, crushed cuts heal slowly and invite disease. On any cut over three centimetres in diameter, apply a pruning sealant to the cut face immediately. This is not universally recommended for all species but it makes sense for Prunus on a renovation job, where you are leaving large cut surfaces exposed through the rest of winter.
Stack the cut material clear of the hedge line and dispose of it promptly: chip it, burn it, or remove it from site. Do not leave large piles of Prunus brash in contact with the cut stumps, as decaying Prunus material is a reservoir for silver leaf spores.
Stage 3: first growing season (March to October)
The cut side will push new growth from the stumps in late March and April. Bullace regrowth is vigorous and shoots from below the cut point readily, which is reassuring. By midsummer the cut face should have a good covering of new growth reaching sixty to ninety centimetres. The uncut side of the hedge remains at its previous height and condition through this season, providing structural continuity for the boundary.
Two things to watch during the growing season. First, silver leaf symptoms on the new growth: if leaves on the regenerating cut-side shoots show the characteristic silvery sheen, you have active infection in that section. Cut out and remove any affected material before proceeding with stage 4. Second, rabbit and deer pressure: new Prunus shoots are highly palatable, and a site with significant rabbit numbers will need spiral guards or a temporary fence along the cut side to protect the regrowth until it is above browse height.
The uncut side of the hedge continues to provide fruit and cover through this season. Fieldfares and redwings arriving in October will work the hedge from both sides, picking off the accessible fruit from the bottom of the uncut growth and any fallen fruit below.
Stage 4: second winter cut (late February, year 2)
The second winter completes the renovation. By now the first-cut side has a full season of regrowth, sitting at roughly sixty to ninety centimetres and filling in well. In the second late-February window, cut the remaining uncut side back to match: two metres or slightly lower, clean angled cuts, sealant on the larger faces.
At the same time, look at the first-cut side and do any formative shaping needed: take in any stems that have pushed too far outward, remove any dead or diseased material that has appeared since the stage 2 cut. The goal at the end of stage 4 is a hedge that is consistent along its length, at approximately two metres, with healthy regrowth on both faces and no obvious die-back or silver leaf symptoms.
After: what the hedge looks like from year three onwards
By the third growing season, the hedge is structurally present along its full length. The new growth from both sides has thickened and the base is filling in, though it will take until year four or five before the base density reaches the level of a well-managed mature bullace hedge. The blossom is back in force in April, the fruit is at working height by October, and the hedge line is stock-proof again.
Once renovated, bullace does not need hard cutting every year. An annual or biennial trim with a hedge trimmer or tractor-mounted flail is enough to keep it to size, and the timing for annual maintenance is more forgiving: a late-summer trim in dry August weather is ideal, as it addresses both the silver leaf timing preference and the post-nesting-season safety window. If you cannot get to it in August, late winter is the fallback, using the same dry-conditions guidance as the renovation cut.
The one additional task that a renovated bullace hedge sometimes needs in years two and three is thinning of the basal suckers. Bullace, like blackthorn, can throw suckers from the root system away from the hedge line into the adjacent ground. Left to grow, these become a separate spreading thicket. Cut them off at ground level as they appear: they have no formal connection to the main hedge structure and removing them does not affect the renovation recovery.
How bullace differs from the other Prunus species in the east Kent hedgerow
Blackthorn (Prunus spinosa) is the most common Prunus in east Kent farmland hedgerows and is covered in a separate guide on this site. The main practical difference from bullace is the thorns: blackthorn's spines are formidable and protective clothing is essential for renovation work. Bullace has fewer and shorter thorns and the work is physically easier. Both species are susceptible to silver leaf and both benefit from the same dry-weather cutting preference.
The fruit is the most obvious distinction in the field: blackthorn sloes are round, hard, very tart and ripen in October to December; bullace fruits are slightly larger, also round, range from yellow-green to purple-black depending on the individual plant, and ripen in September to October with a less astringent flavour. If you find a Prunus boundary hedge whose fruit is noticeably larger and rounder than sloes, you are likely looking at bullace rather than blackthorn. The two species can hybridise, and some east Kent field boundaries carry plants that sit somewhere between the two.
Wild plum (Prunus domestica in the broader sense) sometimes appears in older references as a synonym for bullace, and the two are closely related. In practice, what you find in east Kent farmland hedgerows is usually the small-fruited, round-fruited form that most people call bullace, descended from plants introduced into fruit-growing areas centuries ago and since naturalised into the hedgerow landscape. The renovation and management approach is the same regardless of which Prunus subspecies is present.
Related guides
- Renovating an overgrown blackthorn hedge: before, the staged cut, and the thorny detail
- Renovating an overgrown cherry plum hedge: before the summer cut, four stages, and the restored purple boundary after
- Getting the timing right for hedge cutting: nesting season, the WCA 1981 and what I check first
- Farmland boundary hedge management: from annual-cut rut to rotational health
- Planting a new native hedge on farmland: bare plot to established hedge
Got a bullace hedge that needs attention?
Send a couple of photos and a postcode to hello@staplehedges.co.uk or call 07763 100 477. I can tell you whether the hedge wants a staged renovation, a light pull-back, or something more straightforward, and whether the timing is right to start this winter.
Sources: RHS, "Hedge renovation" (rhs.org.uk/plants/types/hedges); RHS, "Silver leaf" (rhs.org.uk/disease/silver-leaf); Ashridge Trees, "Wild plum hedging" (ashridgetrees.co.uk); Wildlife and Countryside Act 1981, section 1; reference video: "Management for Healthy Hedgerows" (WoodlandsTV, YouTube, February 2025).